Hioki 8835-01 - Auto Print (Memory Recorder)

253
────────────────────────────────────────────────────
10.7 Printing Procedure
────────────────────────────────────────────────────
1
0.7.2 Auto Print (Memory Recorder)
NOTE
Print is carried out automatically after a waveform has been captured for the
specified recording length.
Method Screen: STATUS 1
1. Press the STATUS key to call up the STATUS
screen 1.
2. Move the flashing cursor to the auto print item,
as shown in the figure on the left.
3. Use the function keys to make the selection.
: Disable auto print
: Enable auto print
4. Press the START key to start the
measurement.
Print is carried out automatically after a
waveform has been captured for the specified
recording length.
・Information about settings and scale can also be printed at the same time
(see Section 9.3.6).
・If the A/B cursors are used, partical save is applied (see Section 10.7.4).