Hioki 8835-01 - Handling the Floppy Disk; Floppy Disk

278
────────────────────────────────────────────────────
13.2 Handling the Floppy Disk
────────────────────────────────────────────────────
NOTE
Write-protect
set position
Write-protect
unset positio
n
1
3.2.1 Floppy Disk
CAUTIO
N
・If a floppy disk is inserted upside down, backwards, or in the wrong direction
,
the floppy disk or the unit may suffer damage.
・Do not remove the floppy disk while the floppy disk unit is operating (the LED
on the floppy disk unit is on).
・Before shipping the unit, always remove the floppy disk.
NOTE
1
3.2 Handling the Floppy Disk
A floppy disk can be used to store and retrieve measurement and setting data.
The floppy disk must be initialized (formatted) before using it.
If the write-protect tab on the floppy disk is in the set position, the following
operations can not be performed.
・Initialize
・Store
・Delete
・Make dir
・Del dir
Move the write-protect tab to the unset position.
3.5 inch 2HD or 2DD floppy disks can be used.
The following floppy disk formats can be used:
720 KB (IBM PC/AT compatible), 1.2 MB (NEC PC-9801 series), 1.44 MB
(IBM PC/AT compatible or NEC PC-9801 series with 3-mode drive)
・2DD floppy disks formatted in PC9801 640 K-byte format cannot be used.
・When loading data to personal computer via floppy disk, verify that floppy
disk formatted in MEMORY HiCORDER is recognized on desktop.