Hioki 8835-01 - Replacement Procedure

337
────────────────────────────────────────────────────
15.3 Replacement Procedure
────────────────────────────────────────────────────
1
5.3.1 Replacement Procedure 1
1
5.3.2 Replacement Procedure 2
・This section describes how to replace the 8936 ANALOG UNIT, 8938 FFT
ANALOG UNIT, 8939 STRAIN UNIT, 8940 F/V UNIT or 8947 CHARGE
UNIT.
・The following procedure describes how to remove the input unit.
・Install the units by reversing the procedure for removal.
1. Remove the input cables from all input units.
2. Power off the 8835-01 main unit, and disconnect the power cord.
3. Remove the two fixing screws with a Phillips screwdriver, as shown in the
figure below.
4. Grasp the handle and pull the unit out, as shown in the illustration.
・This section describes how to replace the 8937 VOLTAGE/TEMP UNIT or
8946 4 ch ANALOG UNIT.
・The following procedure describes how to remove the input unit.
・Install the units by reversing the procedure for removal.
1. Remove the input cables from all input units.
2. Power off the 8835-01 main unit, and disconnect the power cord.
3. Remove the two fixing screws with a Phillips screwdriver, as shown in the
figure below.
4. Grasp both the BNC connectors and pull the unit out, as shown in the
illustration.