Hioki 8835-01 - Setting Zero Position

118
────────────────────────────────────────────────────
7.3 Making the Settings of the 8936 ANALOG UNIT
────────────────────────────────────────────────────
Displays the type of the installed un
it
7
.3.1 Setting the Waveform Display Color
7
.3 Making the Settings of the 8936 ANALOG UNIT
This section explains the settings of the 8936 ANALOG UNIT.
The 8936 ANALOG UNIT is a unit for measuring the voltage waveforms.
Set the display color for the waveform.
Method Screen: CHANNEL 1, DISPLAY
1. Call up the CHANNEL 1 or DISPLAY screen.
2. Move the flashing cursor to the point shown
in the figure on the left.
3. Use the
JOG control or the function keys to
make the selection.
: Move the arrow up in the selection window.
: Move the arrow down in the selection
window.
: Waveform display is enabled.
: Waveform display is disabled.