1.2.3 Using the Cursors
NOTE
Method Screen: DISPLAY 19-04, 05
1. Move the flashing cursor to the csr item.
2. Use the function keys to select the cursor
shape.
: Disable A/B cursors
: Line cursor (vertical: t, 1/t)
: Line cursor (horizontal: V)
: Trace cursor (the point where the cursor
crosses the waveform)
To use the line cursor (vertical)
(1) Select F2 [ ] (Line cursor, vertical) key.
(2) Press the
SELECT key so that the A.B CSR
LED lights up.
(3) Rotate the
JOG control to move the cursor.
To use the line cursor (horizontal)
(1) Select F3 [ ] (Line cursor, horizontal)
key.
(2) The channel select option appears. Use the
flashing cursor to select the channel for
which you want to read the voltage value
with the A/B cursors. You can specify
different channels for the two cursors.
(3) Press the
SELECT key so that the A.B CSR
LED lights up.
(4) Rotate the JOG control to move the cursor.
・The channel select option does not appear when using the vertical line
cursor.
・Only channels for which a waveform is being displayed can be specified.
・By specifying a different channel for the A and B cursors, a potential
difference between the waveforms in the respective channels can be
determined.
To Next Page
Loading...
