Hioki 8835-01 - Page 284

262
────────────────────────────────────────────────────
11.2 Using the A/B Cursors
────────────────────────────────────────────────────
NOTE
To use the trace cursor
(1) Select F4 [ TRACE CURSOR ].
(2) The channel select option appears. Use the
flashing cursor to select the channel for
which you want to read the trace point with
the A/B cursors. You can specify different
channels for the two cursors.
(3) Press the
SELECT key so that the A.B CSR
LED lights up.
(4) Rotate the JOG control to move the cursor.
・t or V at the cursor position can be
determined.
・When the vertical cursor or trace cursor is
used, cursor measurements are possible also
when one of the cursors is currently off
screen.
When the
SELECT key is used to activate the A/B cursor mode, the trace
cursor can be used, also if it was set to OFF.
Reference When the vertical cursor or the trace cursor is off screen, the VIEW key can
be used to check the cursor position within the total recording length (see
Section 3.1.7).
Moving the cursor
1. Move the flashing cursor to the position
shown in the figure on the left.
2. Use the function keys to select the cursor to
be moved.
: Use one cursor only
: Move the A cursor only
: Move the B cursor only
: Move both the A and B cursors
3. Rotate the JOG control to move the cursor.
(If the A.B CSR LED does not light up, the
cursor cannot be moved.)