.11 Copying Channels
・Duplicates selected input channel configurations (voltage axis range, input
coupling, low-pass filter) and variable function and comment settings to other
channels.
・Channels cannot be copied unless same measuring mode is selected in
channels to copy regardless of status of units.
Method Screen: CHANNEL 1
1. Call up the CHANNEL 1 screen.
2. Use the
CH SELECT key to display channel
screen to copy.
3. Use the cursor key and move the flashing
cursor of desired channel number to copy
shown as figure left.
4. Use the function key or the jog control to
select channel to copy.
When for ALL is selected, channel settings
(comments) indicated by a flashing cursor are
copied to all channels.
: Channel number up
: Channel number down
5. Press Execute function key to copy.
・When copying input channel configuration,
select for ALL to copy magnification and zero
position.
・Input channel configuration, variable function
and comment settings cannot be copied
together at the same time.
・Depending on the waveform display color, the
color of the printer output for either the print
function or the hard copy function changes.
To Next Page
Loading...
