Hioki 8835-01 - RMS Level Trigger (RMS Recorder Function Only)

191
────────────────────────────────────────────────────
8.6 Using the Analog Trigger Function
────────────────────────────────────────────────────
8
.6.5 RMS Level Trigger (RMS Recorder Function Only)
R
MS trigge
r
l
evel
R
MS trigge
r
l
evel
U
pward trigger direction (slope :
)
D
ownward trigger direction (slope :
)
I
nput waveform
・The commercial power supplies, 50/60 Hz and the DC signals can be
measured.
・This trigger occurs when the input signal crosses a predetermined trigger level
(rms value) in a particular direction ("slope":
or ).
Method Screen: STATUS 2, DISPLAY
1. Select the RMS level trigger.
(1) Call up the STATUS 2 or DISPLAY screen.
(2) Move the flashing cursor to the position
shown in the figure on the left.
(3) Use the function keys to select RMS.