Hioki 8835-01 - Page 214

192
────────────────────────────────────────────────────
8.6 Using the Analog Trigger Function
────────────────────────────────────────────────────
NOTE
Upward trigger direction
(slope : )
If the input signal is highe
r
than the trigger level.
Downward trigger direction
(slope : )
If the input signal is lower
than the trigger level.
2. Set the trigger level.
(1) Move the flashing cursor to the position
shown in the figure on the left.
(2) Use the
JOG control or the function keys to
set the trigger level.
On the DISPLAY screen, the setting cannot
be made with the
JOG control.
: Value up, large step
: Value up, small step
: Value down, small step
: Value down, large step
3. Select the trigger direction (slope).
(1) Move the flashing cursor to the position
shown in the figure on the left.
(2) Use the function keys to select the trigger
direction (slope).
: Enables triggering on the leading edge.
: Enables triggering on the falling edge.
・Set the frequency of the measuring object on the STATUS 1 screen.
・’AND’ cannot be set between the trigger sources using the RMS level trigger
and the logic trigger. When a shift is made from "OR" to "AND," the logic
trigger setting is turned OFF.
・When the trigger source is set as "AND", the trigger is engaged
simultaneously with the start in the following instances.