.2.2 Setting the Time Axis Range and Sampling
NOTE
・Set the speed for inputting and storing the waveform of the input signal.
・Time axis range setting expresses the time for 1 DIV.
・Sampling period settings start at 1 μs (and range up to a maximum of
1 MS/s). The available range depends on the selected time axis range (input
signal waveform capture rate).
Method 1 Screen: STATUS 1, DISPLAY
1. Call up the STATUS 1 or DISPLAY screen.
2. Move the flashing cursor to the time/div item,
as shown in the figure on the left.
3. Use the
JOG control or the function keys to
make the selection.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
On the DISPLAY screen, the setting cannot be
made with the
JOG control.
4. Set the sampling period (STATUS 1 screen
only).
(Move the flashing cursor to the position
shown in the figure on the left. Use the
JOG
control or the function keys to make the
selection.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
To Next Page
Loading...
