Hioki 8835-01 - Page 217

195
────────────────────────────────────────────────────
8.7 Using the Logic Trigger Function
────────────────────────────────────────────────────
OR
Trigger patter
n
CHA1
1
CHA2
0
CHA3 ×
CHA4 ×
AND
Trigger patter
n
CHA1
1
CHA2
0
CHA3 ×
CHA4 ×
(3) Set the trigger pattern
・When "CH A" is selected, the setting is for logic input CH A1 - CH A4 from
left to right.
・Make the setting with the function keys.
1. Move the flashing cursor to the position
shown in the figure on the left.
2. Select 1 - 4 with the function key display.
: Signal disregarded
: Low level signal
: High level signal
Setting example of the logic trigger
(1) If the trigger pattern has been set to "10××" with the operator OR, then
triggering occurs as shown in the figure below.
(2) If the trigger pattern has been set to "10××" with the operator AND, then
triggering occurs as shown in the figure below.