266
────────────────────────────────────────────────────
11.4 Zoom Function
────────────────────────────────────────────────────
NOTE
: Time axis direction magnification up
: Time axis direction magnification down
: Enables operations on the standard screen
: Enables operations on the zoom screen
: Terminates the zoom function
5. To terminates the zoom function, press the
function key [close].
・The A/B cursors can be used only for the waveform on the lower screen.
・During the zoom function, pressing the
PRINT key prints the waveform on
the lower screen. (The waveform becomes that of the one screen display. If
the A/B cursors are used, partial print is applied.)
・The time axis direction magnification indicates the magnification in relation
to the original waveform both in the case of the standard display and the in
the case of the zoom display.
・The display magnification of the lower display can only be set at a value
that exceeds the magnification of the upper display. (E.g., if the upper
magnification is ×1, the lower can only be set to ×2, 5 or 10. If the upper is
×10, this should be decreased to ×5 and the lower set to ×10.)
・Scrolling the waveform with the jog button is executed on the lower display.
When the lower waveform is scrolled, the brackets indicating the range of
the upper display also move.
(When the lower waveform is scrolled beyond the range indicated at the top,
redisplay the upper waveform. Display it so that the range displayed at the
bottom is at the center of the screen.)
・When the zoom function is used, the logic waveform display positions are
indicated on the screen provided they are 1 to 4. If 5 to 8, the positions are
not indicated.
To Next Page
Loading...
