236
────────────────────────────────────────────────────
9.6 Interface Settings (Media Settings)
────────────────────────────────────────────────────
Preparations for Setting Parameters
When connecting to an existing network, the following parameters must be set
up. Ask the administrator (department) of the network system to assign the
following in advance:
* Host name and address of the 8835-01
Host name (up to 12 characters) :
IP address : . . .
Subnet mask : . . .
* Gateway
Gateway : Used/not used
IP address (when using gateway) :
* TCP/IP Port No. : X (default: 880X)
(Specify the three leftmost digits of the four digits. Numbers 0 to 9 in the
least significant digit are used by the 8835-01 or reserved. Specify the port
No. when default numbers 8800 to 8809 are not available.)
When setting up a network when only using a PC and recorders, not
connecting to an existing network, for example, set the parameters as shown
below.
IP address of PC : 192.168.0.1
IP address of 1st recorder : 192.168.0.2
2nd : 192.168.0.3
3rd : 192.168.0.4
4th : 192.168.0.5
↓ ↓
Host name : Enter the desired name (each host name must be unique).
Subnet mask : 255.255.255.0
Gateway : OFF
Port No. : 880x
Setting Individual Parameters
Once the LAN card is inserted, setting parameters appear on the SYSTEM 4
INTERFACE screen as shown below. Move the cursor to a parameter you
want to set up. After making all necessary setting changes, press F5 [Enter] to
confirm. Otherwise, the changes will not be reflected.
Host Name
Set the name to represent the 8835-01 on the network. Choose a unique name
that is different from those of other devices on the network. When using the
9333 LAN COMMUNICATOR, note that the host name is used to identify a
directory on the PC.
To Next Page
Loading...
