237
────────────────────────────────────────────────────
9.6 Interface Settings (Media Settings)
────────────────────────────────────────────────────
IP Address
Set the IP address of the 8835-01.
The IP address is used to identify individual devices on a network. Set a
unique address that is different from those of other devices on the network.
Subnet Mask
Subnet mask is used to divide an IP address into a network address and host
address. Set the subnet mask the same way that subnet masks of other
devices on the network are set up.
Gateway ON/OFF and IP Address
Set the default gateway (default router).
Turn this ON and specify the IP of the device serving as a gateway when the
8835-01 communicates with a device (PC) on a network other than its own
network. When the PC is on the same network, use the default gateway of the
PC. When the 8835-01 is connected one-to-one with a PC or both are
connected to the same hub, a gateway is not necessary. Turn it off.
Data Acquisition Server IP
Specify the PC that runs the 9333 LAN COMMUNICATOR, with which the
8835-01 communicates. This setting is required for acquiring data using the
9333 LAN COMMUNICATOR.
When acquiring data using the 9333:
* To send measurement data (saved by using the Auto Save function) to the
9333, set Media on Status 1 screen to COMMUNI (LAN). (Real-time transfer
of measurement data is not available.)
* To send an Auto Print image to the 9333, set Auto Print destination on
Status 1 screen to COMMUNI (LAN).
* To send parameter calculation results to the 9333, set Result Save on Status
3 screen to COMMUNI (LAN).
* To send a screen image by using the COPY key, set Copy Destination on
System 4 screen to COMMUNI (interface).
* To send a print image by using the
PRINT key, set Output Destination on
System 4 screen to COMMUNI (interface).
Port No.
The 8835-01 uses TCP/IP for communications. TCP/IP allows multiple
connections for different types of communications. A port number identifies
each connection. The 8835-01 uses port numbers 8800 to 8809.
* 8800 (8835-01 as the server.) : Used by the 9333 remote control application.
* 8801 (8835-01 as the client) : Used by the 9333 data acquisition
application.
* 8803 (8835-01 as the server) : Used with communications commands.
* 8802 to 8809 : Reserved
You need not edit the port number setting, unless some ports are not available
due to security reasons or not available on the PC with which the 8835-01
communicates.
This sets the three leftmost digits only. The rightmost digit (from 0 to 9) is
used by the 8835-01 or reserved.
To Next Page
Loading...
