238
────────────────────────────────────────────────────
9.6 Interface Settings (Media Settings)
────────────────────────────────────────────────────
Delimiter and Header ON/OFF
Used when applying control by using communications commands.
Header ON/OFF sets whether to add a header in the response to a command.
Delimiter sets whether to use LF or CR+LF for the response to a command.
Both LF and CR+LF are accepted in command transmission. Communications
commands are transmitted by connecting to port 8802 (default) of the 8835-01
using TCP and sending a character string.
■ Connection
After completing the setting above, connect the devices.
* Connecting the 8835-01 to an existing network
Connect the LAN connector of the 8835-01 to the hub using a straight LAN
cable or the 9642 LAN CABLE.
* Connecting the 9941/42 to a PC one-to-one
A cross cable or straight cable and a cross connector are required. (The 9642
straight cable is supplied with a cross connector.)
A 100BASE cable is required for connecting to a 100BASE network using
the 100BASE card.
To Next Page
Loading...
