Hioki 8835-01 - Page 306

284
────────────────────────────────────────────────────
13.3 Handling the PC Card
────────────────────────────────────────────────────
CAUTIO
N
If a PC card is inserted upside down, backwards, or in the wrong direction, the
PC card or the unit may suffer damage.
To avoid damage to the PC card or connector, observe the cautions listed
below.
・Inserting the card with the wrong orientation or in other ways than described
above.
・Inserting the card while attached to the connection cable.
・Moving the 8835-01 while the connection cable is connected to the card.
・Pulling the card out by the cable or exerting excessive force on the
connector.
・Placing objects on the connection cable connector.
Fig. 13.3 PC card insertion
Fig. 13.4 Attaching the protector
Inserting the PC card
1. Insert the PC card in the PC card slot on the 8835-01. Verify that the ▲
mark on the card points in the correct direction as shown below, and make
sure that the card is properly seated in the slot.
The PC card is keyed to prevent wrong insertion, but exerting excessive
force may damage the card or the slot.
2. Attach the PC card protector to the 8835-01 as shown below.