For shipping or long-term storage, be certain that the recording head is in the
raised position. Otherwise the rollers could be deformed and cause uneven
printing.
CAUTIO
・Remove the printer paper from the unit. If the paper is left in the unit, paper
support parts may be damaged due to vibrations.
・To avoid damage to the product, be sure to remove the PC card and floppy
disk before shipping.
・Use the original packing materials when reshipping the product, if possible.
NOTE
WARNIN
Before using the product, make sure that the insulation on the cords and
probes is undamaged and that no bare conductors are improperly
exposed. Using the product under such conditions could result in
electrocution. Replace the cords and probes specified by HIOKI.
(6) Recording paper
･ This unit uses a thermal printer. The recording paper supplied has
characteristics finely tuned for use with the printer.
Using recording paper of a different specification may not only result in
impaired printing quality, but even prevent the printer from operating.
Always use the HIOKI specified product.
･ Insert the paper with correct orientation (see Section 2.7).
(7) Using a printer
Avoid using the printer in hot, humid environments, as this can greatly reduce
printer life.
(8) Storing
(9) Shipping
(10) Others
･ In the event of problems with operation, first refer to Section 16.3,
"Troubleshooting."
･ Carefully read and observe all precautions in this manual.
Preliminary Checks
Before using the product the first time, verify that it operates normally to
ensure that the no damage occurred during storage or shipping. If you find
any damage, contact your dealer or HIOKI representative.
To Next Page
Loading...
