74
────────────────────────────────────────────────────
4.4 Processing Functions (Waveform Parameter Processing)
────────────────────────────────────────────────────
X-Y waveform
X-Y waveform (no enclosed range)
Shaded area is
calculated
Line area is
calculated
NOTE
(14) X-Y area value
・Calculates the area (V
2
) after X-Y plotting.
・The waveform is plotted on the X-Y screen, and the area enclosed by the plot
lines is calculated.
・In single, dual, or quad screen, the A/B cursors (vertical, trace) can be used to
specify the range for X-Y plotting and area calculation.
・On the X-Y screen of the memory recorder function, it is not possible to specify
the range with the A/B cursors.
・Refer to Section 11.2 Using the A/B Cursors, for more information on cursor
operation.
･ Depending on the signal waveform, values for parameters (8), (9), (10), and
(11) may not be displayed.
･ When the scaling function is used, scaling is first applied to waveform data,
and then the parameters are calculated. The parameter unit is determined by
the scaling unit (
Section 9.4).
To Next Page
Loading...
