Keysight E4981A - Page 211

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 211
Command Reference
E4981A SCPI Commands
When specifying BUF3 as parameter (Comparator: ON)
{numeric 1},{numeric 2},{numeric 3},{numeric 4},…,{numeric (N×4)}<newline><^END>
The N sets of measurement data (a data set consists of the measurement
status, measured value, and comparator sorting result) fed into the data buffer
are read out in the order of measurement.
Where N is the number of measurement points specified with the
:DATA:POINts:BUF3 command and n is an integer between 1 and N:
Related commands :DATA:FEED:BUF1 on page 195
:DATA:FEED:CONTrol[:STATe] on page 200
:DATA:POINts:BUF1 on page 202
:DATA:POINts:BUF2 on page 203
:DATA:POINts:BUF3 on page 204
:CALCulate3:MATH:STATe on page 194
:CALCulate4:MATH:STATe on page 194
:FETCh? on page 220
:FORMat[:DATA] on page 225
Equivalent key
sequence
No equivalent key is available on the front panel.
{numeric (n–1)×3+1}
The measurement status in the n-th measurement (an integer
between 0 and 2).
{numeric (n–1)×3+2}
The measured value of the primary parameter in the n-th
measurement. If overload is detected, 9.9E37 is outputted.
{numeric (n–1)×3+3}
The measured value of the secondary parameter in the n-th
measurement. If overload is detected, 9.9E37 is outputted.
{numeric (n–1)×3+4}
The comparator sorting result in the n-th measurement (an
integer between 0 and 11). The output (output value is 11) is
produced even if the comparator is off.