Keysight E4981A - Page 241

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 241
Command Reference
E4981A SCPI Commands
• When specifying STAN2 as parameter 1:
• When specifying STAN3 as parameter 1:
In any case, if the specified parameter is out of the allowable setup range, the
minimum value (if the lower limit of the range is not reached) or the maximum
value (if the upper limit of the range is exceeded) is set.
Query response {numeric 1},{numeric 2}<newline><^END>
Related commands [:SENSe]:CORRection:OPEN[:STATe] on page 248
[:SENSe]:CORRection:SHORt[:STATe] on page 249
[:SENSe]:CORRection:LOAD[:STATe] on page 242
[:SENSe]:CORRection:MULTiple[:STATe] on page 245
[:SENSe]:CORRection:MULTiple:CHANnel on page 243
[:SENSe]:CORRection:CKIT:STAN1:FORMat on page 233
[:SENSe]:CORRection:CKIT:STAN2:FORMat on page 234
[:SENSe]:CORRection:CKIT:STAN3:FORMat on page 236
:FORMat[:DATA] on page 225
Parameter 2: <numeric 1> Parameter 3: <numeric 2>
Description
Value of the primary parameter
1
.
Value of the secondary
parameter
*1
.
Range -99.9999E9 to 99.9999E9 -99.9999E9 to 99.9999E9
Initial value 0 0
Unit Depends on the type of parameter. Depends on the type of parameter.
1. Use the [:SENSe]:CORRection:CKIT:STAN2:FORMat command to
specify the type of parameter.
Parameter 2: <numeric 1> Parameter 3: <numeric 2>
Description
Value of the primary parameter
1
.
Value of the secondary
parameter
*1
.
Range -999.999 to 999.999 -99.9999E9 to 99.9999E9
Initial value 100E-9 0
Unit F (farad) Depends on the type of parameter.
1. Use the [:SENSe]:CORRection:CKIT:STAN3:FORMat command to
specify the type of parameter.