Keysight E4981A - Page 312

312 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
SCPI Command Table
10-
Contact Check Data buffer setup Feeding target parameter [:SENSe][:FIMPedance]:CONTact1:VERify:BUF1:F
EED:CONTrol:INTerval on page 254,
[:SENSe][:FIMPedance]:CONTact1:VERify:BUF2:F
EED:CONTrol:INTerval on page 257
Control (feed/not feed) [:SENSe][:FIMPedance]:CONTact1:VERify:BUF1:F
EED:CONTrol[:STATe] on page 255,
[:SENSe][:FIMPedance]:CONTact1:VERify:BUF2:F
EED:CONTrol[:STATe] on page 258
Buffer size [:SENSe][:FIMPedance]:CONTact1:VERify:BUF1:P
OINts on page 256,
[:SENSe][:FIMPedance]:CONTact1:VERify:BUF2:P
OINts on page 259
Key lock ON/OFF :SYSTem:KLOCk on page 283
Beeper ON/OFF :CALCulate1:COMParator:BEEPer[:STATe] on
page 174, :SYSTem:BEEPer:STATe on page 273
Beep mode setup :SYSTem:BEEPer:TONE on page 274
Beep ON :SYSTem:BEEPer[:IMMediate] on page 273
Comparator Beep condition :CALCulate1:COMParator:BEEPer:CONDition on
page 173
Status report
structure
Clear *CLS on page 157
Status byte register value readout *STB? on page 162
Service request enable register setup *SRE on page 162
Standard event
status register
Register value readout *ESR? on page 158
OPC bit setup *OPC on page 159
Enable register setup *ESE on page 157
Operation status
register
Clear :STATus:PRESet on page 271
Condition register value readout :STATus:OPERation:CONDition? on page 269
Enable register setup :STATus:OPERation:ENABle on page 270
Event register value readout :STATus:OPERation[:EVENt]? on page 270
Table 10-1 SCPI command table
Function Item to Be Set Up/Executed SCPI Command