LevelOne GEL-5261 - Figure 50: Enabling LACP on a Port; Figure 51: Configuring LACP Parameters on a Port

Chapter 4 | Interface Configuration
Trunk Configuration
– 123 –
6. Click Apply.
Figure 50: Enabling LACP on a Port
To configure LACP parameters for group members:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Configure from the Action list.
4. Click Actor or Partner.
5. Configure the required settings.
6. Click Apply.
Figure 51: Configuring LACP Parameters on a Port