To show the active members of a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step list.
3.
Select Show Member from the Action list.
4.
Select a Trunk.
Figure 52: Showing Members of a Dynamic Trunk
To configure connection parameters for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step list.
3.
Select Configure from the Action list.
4.
Modify the required interface settings. (See “Configuring by Port List” on
page 98 for a description of the interface settings.)
5.
Click Apply.
Figure 53: Configuring Connection Settings for a Dynamic Trunk
To Next Page
Loading...
