Interface Configuration
This chapter describes the following topics:
◆
Port Configuration – Configures connection settings, including auto-
negotiation, or manual setting of speed, duplex mode, and flow control.
◆
Displaying Statistics – Shows Interface, Etherlike, and RMON port statistics in
table or chart form.
◆
Displaying Statistical History – Displays statistical history for the specified
interfaces.
◆
Displaying Transceiver Data – Displays identifying information, and operational
parameters for optical transceivers which support DDM.
◆
Configuring Transceiver Thresholds – Configures thresholds for alarm and
warning messages for optical transceivers which support DDM.
◆
Cable Test – Performs cable diagnostics on the specified port.
◆
Trunk Configuration – Configures static or dynamic trunks.
◆
Saving Power – Adjusts the power provided to ports based on the length of the
cable used to connect to other devices.
◆
Local Port Mirroring – Sets the source and target ports for mirroring on the local
switch.
◆
Remote Port Mirroring – Configures mirroring of traffic from remote switches
for analysis at a destination port on the local switch.
◆
Flow Sampling – Configures periodic sampling of traffic flows.
◆
Traffic Segmentation – Configures the uplinks and down links to a segmented
group of ports.
To Next Page
Loading...
