LevelOne GEL-5261 - Figure 277: Configuring Global Settings for LBD

Chapter 13 | Basic Administration Protocols
LBD Configuration
– 434 –
When the loopback detection response is changed, any ports placed in
shutdown state by the loopback detection process will be immediately
restored to operation regardless of the remaining recover time.
◆ Trap – Sends a trap when a loopback condition is detected, or when the switch
recovers from a loopback condition. (Options: Both, Detect, None, Recover;
Default: None)
■
Both – Sends an SNMP trap message when a loopback condition is
detected, or when the switch recovers from a loopback condition.
■
Detect – Sends an SNMP trap message when a loopback condition is
detected.
■
None – Does not send an SNMP trap for loopback detection or recovery.
■
Recover – Sends an SNMP trap message when the switch recovers from a
loopback condition.
◆ Release – Releases all interfaces currently shut down by the loopback
detection feature.
Web Interface
To configure global settings for LBD:
1. Click Administration, LBD, Configure Global.
2. Make the required configuration changes.
3. Click Apply.
Figure 277: Configuring Global Settings for LBD