Modify
◆
VLAN ID
– ID of configured VLAN (1-4094).
◆
VLAN Name – Name of the VLAN (1 to 32 characters).
◆
Status – Enables or disables the specified VLAN.
◆
L3 Interface – Sets the interface to support Layer 3 configuration, and reserves
memory space required to maintain additional information about this interface
type. This parameter must be enabled before you can assign an IP address to a
VLAN (see “Setting the Switch’s IP Address (IP Version 4)” on page 499).
Show
◆
VLAN ID
– ID of configured VLAN.
◆
VLAN Name – Name of the VLAN.
◆
Status – Operational status of configured VLAN.
◆
Remote VLAN – Shows if RSPAN is enabled on this VLAN (see “Configuring
Remote Port Mirroring” on page 134).
◆
L3 Interface – Shows if the interface supports Layer 3 configuration.
Web Interface
To create VLAN groups:
1.
Click VLAN, Static.
2.
Select Add from the Action list.
3.
Enter a VLAN ID or range of IDs.
4.
Check Status to configure the VLAN as operational.
5.
Specify whether the VLANs are to be used for remote port mirroring.
6.
Click Apply.
To Next Page