■
Exec – Administrative accounting for local console, Telnet, or SSH
connections.
◆
Privilege Level – The CLI privilege levels (0-15). This parameter only applies to
Command accounting.
◆
Method Name – Specifies an accounting method for service requests. The
“default” methods are used for a requested service if no other methods have
been defined. (Range: 1-64 characters)
Note that the method name is only used to describe the accounting method
configured on the specified RADIUS or TACACS+ servers. No information is sent
to the servers about the method to use.
◆
Accounting Notice – Records user activity from log-in to log-off point.
◆
Server Group Name
- Specifies the accounting server group. (Range: 1-64
characters)
The group names “radius” and “tacacs+” specifies all configured RADIUS and
TACACS+ hosts (see “Configuring Local/Remote Logon Authentication” on
page 237). Any other group name refers to a server group configured on the
Security > AAA > Server (Configure Group) page.
Configure Service
◆
Accounting Type – Specifies the service as 802.1X, Command or Exec as
described in the preceding section.
◆
802.1X
■
Method Name – Specifies a user defined accounting method to apply to
an interface. This method must be defined in the Configure Method page.
(Range: 1-64 characters)
◆
Command
■
Privilege Level
– The CLI privilege levels (0-15).
■
Console Method Name – Specifies a user-defined method name to apply
to commands entered at the specified CLI privilege level through the
console interface.
■
VTY Method Name – Specifies a user-defined method name to apply to
commands entered at the specified CLI privilege level through Telnet or
SSH.
◆
Exec
■
Console Method Name – Specifies a user defined method name to apply
to console connections.
To Next Page
Loading...
