■
Inform – Notifications are sent as inform messages. Note that this option is
only available for version 2c and 3 hosts. (Default: traps are used)
■
Timeout – The number of seconds to wait for an acknowledgment
before resending an inform message. (Range: 0-2147483647
centiseconds; Default: 1500 centiseconds)
■
Retry times – The maximum number of times to resend an inform
message if the recipient does not acknowledge receipt.
(Range: 0-255; Default: 3)
◆
Local User Name – The name of a local user which is used to identify the
source of SNMPv3 trap messages sent from the local switch. (Range: 1-32
characters)
If an account for the specified user has not been created (page 376), one will be
automatically generated.
◆
Remote User Name – The name of a remote user which is used to identify the
source of SNMPv3 inform messages sent from the local switch. (Range: 1-32
characters)
If an account for the specified user has not been created (page 379), one will be
automatically generated.
◆
UDP Port – Specifies the UDP port number used by the trap manager.
(Default: 162)
◆
Security Level – When trap version 3 is selected, you must specify one of the
following security levels. (Default: noAuthNoPriv)
■
noAuthNoPriv – There is no authentication or encryption used in SNMP
communications.
■
AuthNoPriv – SNMP communications use authentication, but the data is
not encrypted.
■
AuthPriv – SNMP communications use both authentication and
encryption.
Web Interface
To configure trap managers:
1.
Click Administration, SNMP.
2.
Select Configure Trap from the Step list.
3.
Select Add from the Action list.
4.
Fill in the required parameters based on the selected SNMP version.
To Next Page
Loading...
