Displaying LACP Settings and Status for the Remote Side 128
Configuring Load Balancing 129
Saving Power 131
Configuring Local Port Mirroring 132
Configuring Remote Port Mirroring 134
Sampling Traffic Flows 138
Configuring sFlow Receiver Settings 139
Configuring an sFlow Polling Instance 141
Traffic Segmentation 143
Enabling Traffic Segmentation 143
Configuring Uplink and Downlink Ports 144
5
VLAN Configuration 147
IEEE 802.1Q VLANs 147
Configuring VLAN Groups 149
Adding Static Members to VLANs 152
IEEE 802.1Q Tunneling 156
Enabling QinQ Tunneling on the Switch 160
Creating CVLAN to SPVLAN Mapping Entries 161
Adding an Interface to a QinQ Tunnel 163
Protocol VLANs 164
Configuring Protocol VLAN Groups 165
Mapping Protocol Groups to Interfaces 166
Configuring MAC-based VLANs 168
6
Address Table Settings 171
Displaying the Dynamic Address Table 171
Clearing the Dynamic Address Table 172
Changing the Aging Time 173
Configuring MAC Address Learning 174
Setting Static Addresses 176
Issuing MAC Address Traps 178
7
Spanning Tree Algorithm 181
Overview 181
Configuring Loopback Detection 183
To Next Page
Loading...
