1058 Matrix ETERNITY NE System Manual
• Subnet Mask: This is the mask to be applied on destination address.
• Gateway Address: This is the IP address of the node where the IP packets are to be sent. Generally, it
is the IP address of the LAN interface of the Router.
The Gateway Address must be in the same subnet as SARVAM UCS.
Click Submit.
IPv6 Addresses table
For each entry, you must configure the following fields:
• Destination Address: This is the address of the final destination where the call is to be made. This
can be a device IP Address or Network Address.
Valid Range of the IPv6 Address is A to F, a to f, 0 to 9,:(colon). It can be a maximum of 39 characters.
Default: Blank.
• Prefix Length: The Prefix Length is a decimal value that indicates how many of the high-order
contiguous bits of the destination address comprise the prefix (the network portion of the address).
The Prefix Length range is from 1 to 128 bits. Default: Blank.
• Gateway Address: This is the IP address of the node where the IP packets are to be sent. Generally, it
is the IP address of the LAN interface of the Router.
The Gateway Address must be in the same subnet as SARVAM UCS.
Click Submit.
The CPU Card will restart after the Static Routing parameters have been configured.
To take the above example further, the Static Routing Table of SARVAM UCS at Location A should be
configured as:
• The Destination Address 192.168.2.0 specifies the network address of Location B.
• The Subnet Mask is the mask to be applied on the Destination address.
• The Gateway Address 192.168.1.1 specifies the LAN address of the Router A which connects location
A and location B.
Index Destination Address Subnet Mask Gateway Address
1 192.168.2.0 255.255.255.0 192.168.1.1
2
:
8
To Next Page
