Matrix ETERNITY NE System Manual 97
The command for entering SA mode is also non-configurable. See the topic “Access Codes” under Features and
Facilities.
To know how to use/change feature settings with SA Commands, please refer the description of individual features
under “Features and Facilities”.
SA Password for programming from extensions
The access to SA mode may be protected by means of an SA Password.
The SA Password is code for preventing unauthorized access to the SA mode. The password can be a minimum of
4 digits to a maximum of 12 digits. The valid digits are from 0 to 9. You can log into the SA mode from extensions
only after you have set the SA Password from the SE mode through Jeeves. To avoid unauthorized access, we
recommend you to change the password. Make sure it is strong and is kept confidential. It can be changed and
reset by the System Engineer.
Refer the topic “System Security” for instructions on how to change and reset the SA Password.
• When SARVAM UCS is used in the Standard PBX Application, you can enter SA mode only from
extensions which have the features 'SA Mode' and/or 'SA Extension’ enabled in their Class of Service.
• When the feature ‘SA Extension’ is enabled in the Class of Service of an extension, the extension will
always be in SA mode. You do not need to enter SA mode by dialing the SA password. You can enter
the SA mode by dialing the SA command prefix string.
• When the feature 'SA Mode' is enabled in the Class of Service of an extension, dialing of the SA
Password is required to enter the SA mode. SA Commands can be dialed only after successfully
entering the SA Mode.
• There is no restriction on the number of persons who can simultaneously enter and operate from the
SA mode using a telephone.
Entering SA Mode using a Telephone
To enter SA mode from an extension phone (for all countries except New Zealand),
•Dial 1#92-SA Password
• You get a confirmation Tone.
• Dial SA Command strings: 1072-Feature Access Code.
• You get a confirmation tone and text message on the phone display.
• Replace handset to exit SA mode.
OR
•Dial 1#92
To enter SA mode from an extension phone (for New Zealand),
•Dial *1#92-SA Password
• You get a confirmation Tone.
• Dial SA Command strings: 1072-Feature Access Code.
• You get a confirmation tone and text message on the phone display.
• Replace handset to exit SA mode.
OR
•Dial *1#92
To Next Page
Loading...
