98 Matrix ETERNITY NE System Manual
You can exit from the SA mode automatically or manually. To exit the SA mode automatically, you must
configure the SA Mode Timer. On the expiry of the set time, the system disconnects the extension phone
from the SA mode. This Timer is loaded automatically every time a new SA command is issued.
To configure the SA Mode Timer:
•Dial 1072-016-SA Mode Timer
Where,
SA Mode Timer = 000 to 255 minutes.
Default: 003 minutes.
• You can also exit the SA mode before the SA Mode Timer expires by dialing the command to exit the SA
Mode. If the SA Mode Timer is set to 000 minutes, you can exit the SA mode only by dialing the command.
You may change the SA Mode Timer from the SA mode of Jeeves also.
Changing Login Session Time Out of Jeeves
As mentioned earlier, each login session of Jeeves has been set to 60 minutes by default. The Login session will
expire at the end of 60 minutes. The duration of the Login session can be changed as per your preference by
changing the settings of the Web Configuration Time Out Timer.
To do this:
•Dial 1#91-SE Password to enter SE mode from a SLT.
•Dial 2118-Time
Where,
Time is from 001 to 255 minutes.
For example, to set log out time to 45 minutes, dial 2118-045.
• Press 'Enter' key to save setting.
Logging Out Users from Jeeves
It is possible for four users to simultaneously login as System Engineers and use Jeeves. It is also possible to log
out all these users at once or log out any of these users selectively. To do this,
•Dial 1#91-SE Password to enter SE mode from a SLT.
•Dial 2188 to log out all users.
• Press Enter key to save setting.
To Next Page
Loading...
