Matrix ETERNITY NE System Manual 1207
• Dial 1 to confirm the time set for alarm VMS responds with: "Your Wake up Alarm is set." followed by
the prompt: "Thanks for using this Service."
• If alarm is not set, the VMS responds with: "Sorry! Your Wake Up Alarm cannot be set. Please call
Operator for further assistance.". VMS further responds with: "Thanks for using this Service."
Daily Alarm
•Dial 2 VMS responds with: "You have set Daily Wake up Alarm at …." followed by the prompt: "To
Confirm, Press 1, To Re-enter, Press 2."
• Dial 1 to confirm the time set for alarm VMS responds with: "Your Daily Wake up Alarm is set." followed
by the prompt: "Thanks for using this Service."
• If no alarm is set, the VMS responds with: "Sorry! Your Wake Up Alarm cannot be set. Please call
Operator for further assistance." . The VMS further responds with: "Thanks for using this Service."
• Dial # (pound/hash) to cancel all alarms VMS responds with: "Your all Wake up Alarm are cancelled."
followed by the prompt: "Thanks for using this Service."
• If no alarms are set, the VMS responds with: "Sorry! There is no Alarm to cancel." followed by the
prompt: "Thanks for using this Service."
Alarm set by Operator
• Enter System Administrator Mode, dialing 1072.
• Dial 034 the VMS prompts: "Enter the Extension number for which you have to set or cancel Wake Up
Alarm."
• Dial 1 to select the extension user for which the Alarm is to be set. VMS responds with: "Enter the time, HH
MM in twenty-four hour format. To cancel all alarms, press '#’ (pound/hash)'."
• If no time is entered, the VMS prompts: "You have not entered any input"
• If invalid time is entered, the VMS prompts: "You have entered invalid input."
• To set alarm, dial valid time VMS prompts: "To set once, Press '1', To set Daily Press '2'."
Once Only
•Dial 1 the VMS responds with: "To set it as Personal, Press 1. To set it as Automated, Press 2."
• Dial 1 VMS responds with: "You have set Personal Wake up alarm at…." followed by the prompt: "To
Confirm, Press 1, To Re-enter, Press 2."
• Dial 1 VMS responds with: "Your Personal Wake up Alarm is set." followed by the prompt: "Thanks
for using this Service."
• If alarm is not set, the VMS responds with: "Sorry! Your Wakeup Alarm cannot be set. Please call
Operator for further assistance." VMS further responds with: "Thanks for using this Service."
OR
• Dial 2 the VMS responds with: "You have set Automated Wake up alarm at…." followed by the
prompt: "To Confirm, Press 1, To Re-enter, Press 2."
To Next Page
