Matrix ETERNITY NE System Manual 119
• Double-click the field. A multiple selection box opens.
On the left, the trunks appear with their names (if configured in “Trunks”) and port numbers in a
sequence, starting with CO trunks, followed by Mobile trunks and SIP trunks.
If you have not assigned any names to the trunks, they will appear with their default names (CO,
MOBILE, SIP) and port numbers.
• To select a trunk, place your cursor on the desired trunk, and click Select>>.
OR
• Press the ctrl key and click the left mouse button to select multiple trunks.
• You may change the sequence of the trunks you selected, if required, using the Up and Down arrow
buttons on the right display box.
• To remove (delete) any trunks from the list, press the Delete key of your keyboard.
• You may enable Rotation, if you have selected more than one trunk. Default: Enabled.
When you enable Rotation, each new outgoing call is routed through the subsequent trunk in the
group
22
. This ensures equal distribution of outgoing call traffic on all trunks.
When Rotation is disabled, calls are routed through the first trunk in the group. If this trunk is busy, the
call is routed to the next trunk in the group.
Rotation has no relevance if only one member trunk is selected.
• Click OK. The multiple selection box closes.
All the trunks appear in Trunks allowed for dialing ‘0’, in the sequence you selected, separated by
commas.
• To apply Least Cost Routing on the Trunks allowed for 0 dialing, select the desired LCR method from the
combo box:
22. The first call through the first trunk, the second through the second, the third through the third trunk, and so forth. Thus each new
call is routed through the trunk next to the one that routed the previous outgoing call.
To Next Page
Loading...
