156 Matrix ETERNITY NE System Manual
• If required, change the CDC Timer to the desired duration. The range of the timer is 0001 to 9999
seconds. Default: 160 seconds.
• Enable Disconnect Call after CDC Timer check box if you want calls to be disconnected on the
expiry of the CDC Timer. Default: Disabled.
• In the Apply CDC for calls matching with numbers column, type the external numbers on which
you want to apply CDC. You can enter as many as 99 numbers.
• In the Do Not Apply CDC for calls matching with numbers column, enter the numbers which you
want to be exempt from CDC.
• Click Submit.
Priority
Each extension of the SARVAM UCS is assigned a Priority Level starting from 1, 2, 3... to 9, with '1' being lowest
Priority and '9' being highest Priority. Whenever an extension (phone) with higher priority calls an extension with
lower priority, a triple ring is placed on the called extension. To know more, read the feature description “Priority”.
• Select a Priority from 1 to 9 for the SIP extension. Default: 5-Normal.
If this SIP extension is assigned to Operator, you may want to set a higher priority for this extension.
Personal Directory
• Select a Personal Directory number from 01 to 50 that you want to assign to the SIP extension. Default:
None.
A Personal Directory is a list of 25 frequently dialed numbers, each of which are stored by Index number
(location code), Name and Trunk Access Codes (). The Personal Directory is necessary for using the
features “Abbreviated Dialing” and “Dial By Name”.
When a Personal Directory is assigned to an SIP, it must also be configured. The Personal Directory can
be configured also by the extension user. Refer the “Abbreviated Dialing” topic for instructions on
configuring the Personal Directory.
SMS/Email Group Type
• Select the SMS/Email Group Type, you want to assign to the extension user. Default: None.
See “SMS/Email Group” under “SMS Server” to know more.
Time Table
• Select a Time Table for the SIP extension. Default: System Time Table.
If you have not configured Time Table, you may do so now, by clicking the Time Table link. Define the
Working days, and the start and end time of the Working hours and Break hours for each working day.
See “Time Tables” to know more.
Alarm Notification Type
To configure this parameter and for the feature description, see “Alarms” to know more.
To Next Page
Loading...
