Matrix ETERNITY NE System Manual 229
Authenticate
HTTP
Provisioning
request
Select the Authenticate HTTP Provisioning request check box
to authenticate HTTP request for security reason. Default:
Disabled.
If you are using the Open SIP Phone from the Public IP
Address, we recommend you to enable this option.
SARVAM UCS validates the Open SIP Phone on the basis of
the SIP ID and HTTP Authentication Password and provides
configuration on validation.
Make sure, you have configured SIP ID as HTTP User Name
and HTTP Authentication Password as HTTP Password in the
Open SIP Phone.
Panasonic
UTG200B
Registrar
Server
Address
Select the appropriate Registrar Server Address according to
your installation scenario
a
to register the Open SIP Phone with
the SIP Registrar of SARVAM UCS. Default: Use Ethernet IP
Address.
Panasonic
UTG200B
Language Displays the Open SIP Phone language and it is non-editable.
Panasonic
UTG200B
User
Password
Configure the User Password
b
of the Open SIP Phone. It can
be a minimum of 6 characters to a maximum of 16 characters.
Default: userpass
Panasonic
UTG200B
Admin
Password
Configure the Admin Password
c
of the Open SIP Phone. It can
be a minimum of 6 characters to a maximum of 16 characters.
Default: adminpass
Panasonic
UTG200B
Time Zone
Select the Time Zone of the region/country where the Open SIP
Phone is installed. Default: GMT+ 05:30
Panasonic
UTG200B
Daylight
Saving Time
Enable
DST
If DST is applicable, select the Enable DST check box. A list of
DST parameters appear. Configure them as per your
requirement. Default: Disabled.
Panasonic
UTG200B
DST Offset
(min)
Configure the DST Offset in minutes. Valid Range: 0 to 720
minutes. Default: 60 minutes.
Panasonic
UTG200B
Start Day
and Time
of DST
Configure the time from when DST should be applied in the
year, select the Month, Day, Week/Ordinal and Time (hh:mm)
from the corresponding list boxes respectively.
Panasonic
UTG200B
End Day
and Time
of DST
Configure the time when DST should end, select the Month,
Day, Week/Ordinal and Time (hh:mm) from the corresponding
list boxes respectively.
Panasonic
UTG200B
Primary NTP
Server
Select the Primary NTP Server Address with which you want to
synchronize the Date and Time of the Open SIP Phone.
Default: None. Make sure you configure the desired NTP
Server Address/es in the “Third Party IP-Phone General
Parameters”.
Panasonic
UTG200B
To Next Page
Loading...
