246 Matrix ETERNITY NE System Manual
Configuring Htek 802 Open SIP Phones
You are recommended to complete the following steps before connecting the Htek 802 Open SIP Phones:
• Decide the physical location of the Open SIP Phone. It must be connected in the same subnet as that of
the LAN Port of SARVAM UCS.
Time Zone
Select the Time Zone of the region/country where the
Open SIP Phone is installed. Default: India
Snom IP Phone
Date Display
Format
Select the Date Display Format for the Open SIP
Phone. Default: mm/dd
Snom IP Phone
Time Display
Format
Select the Time Display Format for the Open SIP
Phone. Default: 24Hr
Snom IP Phone
Call Progress
Tone
Select the region to apply the Call Progress Tone
prevailing there. Default: India.
Snom IP Phone
HTTP Server
Login Username
Configure the HTTP Server Login User Name for web
access. It can be a maximum of 16 characters.
Default: Blank
Snom IP Phone
HTTP Server
Login Password
Configure the HTTP Server Login Password
b
for web
access. It can be a maximum of 16 characters.
Default: Blank
Snom IP Phone
Admin Mode
Select Admin Mode check box to allow its access to
the user. Default: Enabled
Snom IP Phone
Admin Mode
Password
Configure the Admin Password
c
of the Open SIP
Phone. It can be a minimum of 1 character to a
maximum of 16 characters. Default: 0000
Snom IP Phone
Primary NTP
Server
Select the Primary NTP Server Address with which
you want to synchronize the Date and Time of the
Open SIP Phone. Default: None. Make sure you
configure the desired NTP Server Address/es in the
“Third Party IP-Phone General Parameters”.
Snom IP Phone
a. If the Extended IP phone is in the same network (LAN) as SARVAM UCS, select Use Ethernet IP Address as Registrar Server
Address.
If the Extended IP phone is in the Global Network and SARVAM UCS is connected to Internet over Mobile WAN, select Use Mobile
Port IP Address as Registrar Server Address
If the Extended IP Phone is connected in the Global Network and SARVAM UCS is located behind a NAT Router or STUN is pro-
grammed, select Use Router/STUN's IP Address as Registrar Server Address. Make sure the Router’s Public IP Address is config-
ured in the Network Parameters.
If Dynamic DNS is configured in the Network Parameters, select Use Dynamic DNS Host Name as Registrar Server Address.
If you want SARVAM UCS to assign Registrar Server Address automatically, select Automatic as Registrar Server Address.
b. To avoid unauthorized access, we recommend you to change the HTTP Server Login Password regularly. Make sure it is strong
and is kept confidential.
c. To avoid unauthorized access, we recommend you to change the Admin Password regularly. Make sure it is strong and is kept con-
fidential.
To Next Page
Loading...
