250 Matrix ETERNITY NE System Manual
Registrar
Server
Address
Select the appropriate Registrar Server
Address according to your installation
scenario
a
to register the phone with the SIP
Registrar of SARVAM UCS. Default: Use
Ethernet IP Address.
Matrix SPARSH VP110
Send Phone
Key Settings
Select the Send Phone Key Settings check box
to apply the Phone Key Settings to the phone.
Default: Enabled
Matrix SPARSH VP110
Dial Plan
b
Select the desired Dial Plan. Default: 1
The Phone will detect end of dialing as per the
rules configured in the Dial Plan selected here.
For instructions, see “Dial Plan for SIP
Extension”.
Matrix SPARSH VP110
Transport
Mode
Select the protocol to be used to transport the
SIP messages. Default: TCP
Matrix SPARSH VP110
Enable SRTP?
Select the Enable SRTP? check box for secure
communication over SIP. Default: Disabled
Matrix SPARSH VP110
SIP DiffServe/
ToS
Enter the desired SIP DiffServe/ToS to set the
Quality of Service (QoS) for SIP packets
Default: 26
Matrix SPARSH VP110
RTP DiffServe/
ToS
Enter the desired RTP DiffServe/ToS to set the
Quality of Service (QoS) for RTP packets.
Default: 46
Matrix SPARSH VP110
SIP Port
Enter the port on which the phone will listen for
SIP messages. This port is used to send SIP
messages to the remote peer. Default: 5060
Matrix SPARSH VP110
SIP TLS Port
Enter the port on which the phone will listen for
SIP messages transported over TLS. This port
is used as source port in SIP messages.This
port is also used to send SIP messages to the
remote peer. Default: 5061
Matrix SPARSH VP110
Min RTP Port
To define a range of RTP ports, configure the
minimum local RTP port. Default: 11780
Matrix SPARSH VP110
Max RTP Port
To define a range of RTP ports, configure the
maximum local RTP port. Default: 11800
Matrix SPARSH VP110
Allow HTTP
Select the Allow HTTP check box to enable
HTTP Web access. Default: Enabled
Matrix SPARSH VP110
HTTP Port
Enter the port number on which the HTTP
access is to be given. Default: 80
Matrix SPARSH VP110
Allow HTTPS
Select the Allow HTTPS check box to enable
HTTPS Web access. Default: Enabled
Matrix SPARSH VP110
HTTPS Port
Enter the port number on which the HTTPS
access is to be given. Default: 443
Matrix SPARSH VP110
To Next Page
Loading...
