Matrix ETERNITY NE System Manual 303
If no match is found, the Mobile Port (SIM) will not get registered with any of the available network
operators and no calls can be made or received on this port.
If you change the Network Selection Mode to ‘Manual’ and change the Network Operator Code manually,
the change you made will come into effect only after the system restart.
DSS Key Interface
• Click DSS Key Interface to expand.
This parameter determines what the system should do when an external called party in speech on this
trunk is put on Hold by a Extended IP Phone extension user by pressing a DSS key to dial another port.
For example, the SIP extension user on SIP1 port is in the middle of speech with an external party on a
Mobile 1. If the extension user of SIP1 presses a DSS key to call another extension port, SIP2, two
situations are possible, depending on the DSS Key Interface you configure:
a. The external caller on Mobile 2 will be played music-on-hold, and the user on SIP1 will hear Ring Back
Tone. The call will be placed on SIP2.
b. The external caller on Mobile 1 will be disconnected. SIP1 user will hear Ring Back Tone. The call will
be placed on SIP2.
• Select the radio button of the desired DSS Key Interface option:
• Disconnect current call when Extended IP Phone user presses DSS key of another Trunk,
while in speech on this Trunk
• Put current call on Hold, when Extended IP Phone user presses DSS key of another Trunk,
while in speech on this Trunk. (Default).
Call Cost Calculation
Configure this parameter, if you want to apply Call Cost Calculation feature on the trunk. See “Call Cost Calculation
(CCC)”.
To Next Page
Loading...
