334 Matrix ETERNITY NE System Manual
When you select an RBT Message (1–4), you must record a Voice Module with the desired RBT Message
and assign the Voice Module to Trunk Auto Answer RBT Message application
You can record 4 different RBT Messages for Trunk Auto Answer and assign a different RBT message for
the Day, Break and Night. See “Voice Message Applications” for instructions on recording and assigning
voice modules for RBT messages.
• Select the Trunk Auto Answer Busy Bye Message you want the system to play to callers when the
landing destination extension is busy, from the following options:
• None
• Bye Message1
• Bye Message2
• Bye Message3
• Bye Message4
If you do not want Busy Bye message to be played, select None. The system will not play Busy Tone to
the caller. Default: None.
When you select a Bye Message (1–4), you must record a Voice Module with the desired Bye Message
and assign the Voice Module to Trunk Auto Answer Bye Message application
You can record 4 different Bye Messages for Trunk Auto Answer and assign a different Bye message for
the Day, Break and Night. See “Voice Message Applications” for instructions on recording and assigning
voice modules for Bye messages.
• Follow the same instructions as described above to configure Incoming Call Routing to Route Calls
during Break to and Route Calls during Night to.
RCOC (Return Call to Original Caller)
When RCOC is applied on the SIP Trunk, the system routes calls returned by remote parties back to the extensions
that originally made the call from this port (i.e. the original callers' extensions). To know more, see “RCOC (Return
Call to Original Caller)”.
To apply RCOC (Return Call to Original Caller) on the SIP Trunk,
• Click RCOC to expand.
• Select the check box
Set RCOC for Calling Extension, when Called Number is busy/ switched-off / not
responding. Default: Disabled.
To Next Page
Loading...
