360 Matrix ETERNITY NE System Manual
• Enable Apply CDC for Outgoing Calls made from trunk, if CDC is to be applied to outgoing external
calls. Default: Disabled.
• If required, change the CDC Timer to the desired duration. The range of the timer is 0001 to 9999
seconds. Default: 160 seconds.
• Enable Disconnect Call after CDC Timer check box if you want calls to be disconnected on the expiry
of the CDC Timer. Default: Disabled.
• In the Apply CDC for calls matching with numbers column, type the external numbers on which you
want to apply CDC. You can enter as many as 99 numbers.
• In the Do Not Apply CDC for calls matching with numbers column, enter the numbers which you
want to be exempt from CDC.
• Click Submit.
Priority
• Select a Priority level from 1 to 9 for the trunk. Default: 9-Highest.
Each trunk of the SARVAM UCS can be assigned a Priority Level starting from 1, 2, 3... to 9, with '1' being
lowest Priority and '9' being highest Priority. Whenever there are incoming calls on multiple trunks, the call
on the trunk with higher priority will be answered by the Operator extension first. To know more, see
“Priority”.
Time Table
• Select a Time Table for the SIP trunk. Default: System Time Table.
If you have not configured Time Table, you may do so now,
• Clicking the Settings icon.
• The Time Table page opens.
• Define the Working days, and the start and end time of the Working hours and Break hours for each
working day.
• Click Submit.
• Close the window.
See “Time Tables” to know more.
Forced Account Code
Configure this parameter if you want to apply the Forced Account Code feature on the SIP trunk. See “Account
Codes” to know more about this feature.
• Select the Do not allow Outgoing Calls without Account Code check box to enable Forced Account
code on the trunk. Default: Disabled.
When you enable this check box, the system will prompt extension users to dial the Account Code
whenever they grab this trunk to dial out a number. The system will allow extension users to dial out
numbers only after they have dialed the Account Code or Name.
Account Codes feature must also be enabled in the Class of Service of extension users who are to be
allowed this feature.
To Next Page
Loading...
