Matrix ETERNITY NE System Manual 751
• Match from last digit of CLI
• Match from first digit of the CLI
The method you select will be applicable to all the numbers configured in the CLI Based Routing Table.
• Each number is to be stored at a Location Index numbered from 001 to 400.
There are 100 entries on each page. To go to the next 100 Index, click the numbered links at the top of the
CLI table (101-200, 201-300, 301-400).
• Refer to the table you created on paper, and configure the following parameters.
•In Calling Party’s Number, enter the number of the calling party, not exceeding 16 digits. You can also
enter '+' in the number string.
•In Calling Party’s Name, enter the name of the calling party. You can enter a maximum of 8 characters in
this field.
•In Route to, select the landing destination extension number, which may be a SLT, SIP extension, Virtual
extension or Voice Mail Auto Attendant Profile.
• Click Submit.
To enable CLI Based Routing on the Trunks,
• See Incoming Call Routing under “CO Trunks”, “Mobile Trunks” and “SIP Trunks” for instructions.
To Next Page
Loading...
