Matrix ETERNITY NE System Manual 755
• To select a trunk, place your cursor on the desired trunk, and click Select>>.
Or
• Press the ctrl key and click the left mouse button to select multiple trunks.
• You may change the sequence of the trunks you selected, if required, using the Up and Down arrow
buttons on the right display box.
• To de-select a trunk, place your cursor on the desired trunk and press the Delete key on your
keyboard.
• You may enable Rotation, if you have selected more than one trunk. Default: Disabled.
When you enable Rotation, each new outgoing call is routed through the subsequent trunk in the
group
124
. This ensures equal distribution of outgoing call traffic on all trunks.
When Rotation is OFF, calls are routed through the first trunk in the group. If this trunk is busy, the call
is routed to the next trunk in the group.
Rotation has no relevance if only one member trunk is selected.
• Click OK. The multiple selection box closes.
• All the trunks appear in the Route using Trunks field, in the sequence you selected, separated by
commas.
• Clear the Apply Toll Control check box, if you do not want to apply toll control to the CUG numbers
dialed by you. By default, this check box is enabled and therefore the system will apply toll control to all
the outgoing calls.
• Apply Call Cost: By default, this check box is enabled and the system will calculate the cost of each
call.
For certain calls (internal calls) you do not require the call cost calculation, clear the check box
corresponding to these entries.
• Click Submit.
124. The first call through the first trunk, the second through the second, the third through the third trunk, and so forth. Thus each new
call is routed through the trunk next to the one that routed the previous outgoing call.
To Next Page
Loading...
