784 Matrix ETERNITY NE System Manual
When you enable this check box, you can switch to Day Mode (Working Hrs) or Night Mode (Non-Working
Hrs) as per your requirement. By default, this is disabled.
You cannot switch to Break Hours or As per Timetable assignment using the DSS key. This can be
achieved only by logging in Jeeves or through telephone.
How to use
For Extended IP Phone Users
• Press DSS Key assigned to Day/Night Mode.
When you press the DSS Key of extension, the system overrides the Time Table assigned to that
extension. According to the current Day/Night Mode, it switches to Working Hours/Non-Working Hours.
If you are setting Day Night Mode from an Extended IP Phone using a DSS key with Toggle functionality disabled,
refer the LED indication in table below.
LED Indication on DSS Key assigned to Day Night Mode (without Toggle)
If you are setting Day Night Mode from an Extended IP Phone using a DSS key with Toggle functionality enabled,
refer the LED indication in table below.
LED Indication on DSS Key assigned to Day/Night Mode (with Toggle enabled)
Model Event Color Cadence
SPARSH VP248/SPARSH VP310/
SPARSH VP510
Day Mode Set Blue Continuous ON
Night Mode Set Red Continuous ON
Break Hours Mode Set
Violet
Continuous ON
System set to work as per Time Table -- OFF
Model Present Mode
Next mode on
pressing Day
Night Mode
DSS Key
Color
after
toggle
Cadence
SPARSH VP248/
SPARSH VP310/
SPARSH VP510
As per Time Table
(Day Mode)
Night Mode Red Continuous ON
As per Time Table
(Night Mode)
Day Mode Blue Continuous ON
As per Time Table
(Break Hour Mode)
Day Mode Blue Continuous ON
Day Mode Night Mode Red Continuous ON
Night Mode Day Mode Blue Continuous ON
Break Hour Mode Day Mode Blue Continuous ON
To Next Page
Loading...
