Quality
Code
Quality Description
28 BAD No data found for upper or lower bound value Trend interface specific flag.
32 BAD No data collected (for example, archiving not active.
Trend interface specific flag.
This value is also used to indicate a temporary offline status (for any condition
where sampling was stopped).
64 UNCERTAIN No specific reason.
65 UNCERTAIN No specific reason.
The value has ‘pegged’ at some lower limit.
66 UNCERTAIN No specific reason.
The value has ‘pegged’ at some higher limit.
67 UNCERTAIN No specific reason.
The value is a constant and cannot move.
84 UNCERTAIN Returned value outside its defined limits defined.
In this case the Limits field indicates which limit has been exceeded but the
value can move farther out of this range.
85 UNCERTAIN Returned value outside its defined limits defined.
In this case the Limits field indicates which limit has been exceeded but the
value can move farther out of this range.
The value has ‘pegged’ at some lower limit.
86 UNCERTAIN Returned value outside its defined limits defined.
In this case the Limits field indicates which limit has been exceeded but the
value can move farther out of this range.
The value has ‘pegged’ at some higher limit
87 UNCERTAIN Returned value outside its defined limits defined.
In this case the Limits field indicates which limit has been exceeded but the
value can move farther out of this range.
The value is a constant and cannot move.
192 GOOD -
DeleteTrend
Deletes saved trend data.
Define the name of the trend from which you want to delete logs.
138
HMWIN Studio |User Manual|v206 (2017-06-30) |EN|© 2014-2017 Panasonic Electric Works Europe AG
System actions
To Next Page
Loading...
