Operation 32
V4.2 LabChip GX User Manual PerkinElmer
Continuing a Stopped Run
If a run is stopped before it is complete, you can restart the run to
finish the reading the plate. When you select the wells for the assay,
you should select only the wells that were not read so that the
reading starts with the well that was not completed.
To continue a run:
1 Click Start in the upper-left corner of the main window to open
the Start Run Window.
2 Select the wells that were not read in the previous run,
beginning with the well that was in progress when the run was
stopped.
3 Select the same options for this run as were selected for the
stopped run.
4 Click the Start button to begin.
The run starts with the well that was not completed in the previous
run. A separate data file is created for the current run.
To Next Page
Loading...
