Software Reference 256
V4.2 LabChip GX User Manual PerkinElmer
System Diagnostics Window
Use the System Diagnostics window to run the diagnostics tests on
the LabChip GX or GX II instrument. All tests should be run
periodically to verify proper operation of the instrument. To verify
proper operation of a particular function, you can select specific
tests to run. Only displays when the software is in either Instrument
or Simulation mode.
To open the System Diagnostics window, select Validation ïƒ
Diagnostics.
Figure 119. System Diagnostics Window
The left side of the window displays the tests to run on the
instrument. Expand each section to view all of the tests in each
section. Tests selected with a green check mark will run. To skip a
test, click on the check box to clear the selection. Click on a section
check box to select or clear all of the tests in the section.
To Next Page
Loading...
Need help?
General
