Software Reference 153
V4.2 LabChip GX User Manual PerkinElmer
Error Message Area
Error messages are displayed below the Chip Status and Run
Status on the LabChip GX Main Window.
Error messages can result from hardware or software problems.
Most are the result of peaks not being located by the analysis
algorithms of the software. This can be due to a sample or ladder
peak not appearing as expected. The software settings (in the Peak
Find Tab) can also cause peaks to be undetected, which can cause
errors. Additionally, manually excluding a peak (see page 74) from
analysis (in the Peak Table View) or changing the start or end times
for a run can cause errors with the peak find algorithm.
See “Error Messages” on page 285 for a list of errors and tips on
preventing or resolving errors.
To Next Page
Loading...
Need help?
General
