Troubleshooting and Diagnostics 285
V4.2 LabChip GX User Manual PerkinElmer
Error Messages
Before a run is started and while an assay is running, the
instrument firmware and software checks for errors (e.g.,
disconnected devices, bad parameters, bad data, etc.). If an error is
detected, an error or warning message displays in the Run Status.
Depending on the error, the run may continue or be aborted. The
error or warning message describes the problem and either
contains information on how to resolve the problem or directs you to
call PerkinElmer Technical Support (see page 3).
For specific information about an error or warning message, click
one of the links below.
General Errors
• Device <Name> is Disconnected
• Plate Carrier Motion Blocked
• Home Timeout
• Move Timeout
• Pressure Leak Detected
• Focus Failed
Chip Warnings
• HV Check Failed
• Current Leakage Check Failed
LabChip GX Warnings
• HV Check Failed
• Current Leakage Check Failed
• Chip Temperature Warning
To Next Page
Loading...
