Siemens Hicom 112

Index
A31003-K16-X001-3-7620
,
07/99
Z-6
Hicom 100 E Version 2.1, Service manual
Power supply 2-1, 5-2, 12-19
Power supply (PSU/UPS) 3-34
Power supply (PSU/UPS) - derived voltages
3-34
Printout of updated customer data 4-18
Procedures for satellite PBXs 7-50
Programmimg guide
networking
route assignment 10-11
Programming actuators
allocating extensions and actuators 10-
77
assigning actuator names 10-78
defining actuator response time 10-76
defining the actuator type 10-76
Programming extensions 10-16
station types
stations at the a/b port 10-16
stations at the S0 bus 10-17
stations at the Up0/E port 10-16
Programming function expansions 10-76
Programming guide 10-1
analogue trunk 10-4
changing a trunk call interval 10-5
changing line length 10-6
setting a dial pause 10-5
setting analogue signalling method
10-4
call management 10-39
call allocation for incoming analogue
trunk calls 10-44
call allocation for internal calls 10-45
call allocation with ISDN DDI 10-42
call destination lists 10-46
call groups 10-39
DDI numbers 10-39
defining intercept criteria 10-54
ISDN DDI settings 10-51
reference to call destination lists 10-
42
networking 10-7
analogue networking 10-9
automatic line seizure 10-10
CorNet-N networking 10-7
digit repetition 10-13
rerouting 10-8
route names 10-15
route overflow 10-13
route seizure 10-14
route type 10-12
programming extensions 10-16
station types 10-16
programming function expansions 10-76
programming actuators 10-76
programming sensors 10-78
programming the fax/DDI module 10-
82
programming ISDN lines 10-1
ISDN multiple connection (point-to-
multipoint) 10-3
point-to-point system connection (P P)
10-1
station attributes 10-18
doorphone setup 10-24
individual classes of service 10-18
setting up the door opener 10-27
trunk access 10-30
System settings
alerting tone during conference (as of
SW version 2.0.2) 10-63
Call forwarding in the case of external
call diversion (as of SW version
2.0.2) 10-61
mode in the case of external diversion
(as of SW 2.0.1+) 10-61
setting the V.24 interface baud rate (as
of SW 2.0.1+) 10-58
V.24 port allocation for data output (as
of SW version 2.02) 10-58
system settings 10-57
alerting tone and ring in call diversion
groups 10-63
automatic line reservation (as of SW
version 2.0.2) 10-62
call detail recording 10-72
call list display mode (as of SW version
2.0.2) 10-62
codes 10-65